You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
Repository navigation
CPU thermal throttling not released after cooldown — frequency stuck at 416 MHz (Radxa Cubie A7S / Allwinner A733) #536
After the CPU overheats (due to cooling failure in this case — fan lost power), the thermal governor correctly throttles the CPU to 416 MHz. However, once the board cools down to normal operating temperature (~40°C), the throttling is never released. The CPU stays permanently at 416 MHz until reboot, even with performance governor and manual writes to scaling_max_freq.
The root cause appears to be that cooling_device0 (cpufreq-cpu0) and cooling_device1 (cpufreq-cpu6) keep their cur_state at max even after temperature drops well below trip points. Writing 0 to cur_state has no lasting effect — the thermal governor immediately overrides it back.
Steps to reproduce
Run a CPU stress workload (e.g. sbc-bench.sh -m or 7zr b) without adequate cooling
Let CPU temperature exceed the trip point (~86°C observed on cpul_thermal_zone / cpub_thermal_zone, trip point = 60°C)
Restore cooling — temperature drops back to ~40°C
Observe that CPU frequency remains stuck at 416 MHz indefinitely
Expected behavior
Once temperature drops below trip point, thermal governor should restore normal cpufreq operation and allow frequency to scale up to 1794 MHz (A55) / 2002 MHz (A76).
Actual behavior
CPU stays at 416 MHz. scaling_max_freq reads as 416000 even after writing 1794000/2002000. performance governor has no effect.
Activity